1. Turn your headphones ON.
      • Ensure that there is no audio cable plugged into your headphones.
    2. The Bluetooth LED on the left earcup will blink, indicating that you are in pairing mode.
    3. Connect to your headphones with your phone or music player.
    4. The Bluetooth LED will blink four times to confirm a connection has been made and will remain on.

    To manually initiate pairing mode, press and hold the "b" button for 2 seconds.


    Disconnect & reconnect

    • Push and hold the "b" button to disconnect your Bluetooth connection.
    • To re-pair to your last Bluetooth connected device, press and release the "b" button.

    ANC-only mode

    Enable ANC-only mode by pressing and holding the power button and the "b" button for 1 second.


    Music controls

    • Press and release the "b" button to play or pause music.

    Play it forward

    • Press the "b" button twice to skip to the next track.
    • Press the "b" button twice and hold on the second press to scan forward.

    Take It Back

    • Press the "b" button three times to play the previous track.
    • Press the "b" button three times and hold on the third press to scan backward.

    Taking calls

    • Answer or end a call—single button press.
    • While on an active call, double press to take the call from your phone rather than your headphones.
    • To reject an incoming call, press and hold the "b" button for 2 seconds.


    If you're using Skype, ensure that you're using the latest version, then pair your headphones to your computer.


    Bluetooth status indicators

    LED Status
    Fast Pulsing Searching for Bluetooth Connection
    On (Solid) Connected
Bluetooth Basics—Studio Wireless

Was this helpful?